The IT-800 can either be equipped with a laser scanner or an imager (CMOS-Camera). You will find an overview with all readable codes in the software manual.
Please do not use camera and imager at the same time so that the separate functions do not interfere with each other. The enhanced scanner wedge "ELISA" and the Camera Wedge support switching from one device to the other automatically if you do not want to implement your own solution.
 

Image Scanner Demo

You will find a demo program for simple tests and presentations under the START menu. The imager can read 1D and 2D barcodes.

In the same folder as the demo program you can find the program Image Scanner Read. This scanner wedge is running invisibly in the background and puts the collected to the respectively actual cursor position. If this wedge is used a complex own development can become unnecessary. For better performance of the wedge we recommend disabling word completion at START, SETTINGS, PERSONAL, INPUT.

Imager Setting

Extensive settings for the imager can be done under START, SETTINGS, SYSTEM. The settings will be saved permanently in a configuration menu.

The settings are only valid for the imager wedge and own programs. The Imager Demo (see above) does always run with the default setting.
 

Enhanced Laser and Imager Scanner Application 

As an enhancement to the integrated Imager / Laser Scanner Wedge Application, an Enhanced Laser and Imager Scanner Application ("ELISA") is available with enhanced features such as Bulk Scanning, Aimer Mode, Barcode Filter, Counter Window etc.

Error Checking

Please check the points mentioned below:

• Use one of the trigger keys to start the scanner.
• The Scanner-Wedge can only be used when the symbol for the scanner is displayed in the status bar.
• The scanner only processes codes that have been activated with the matching settings.
• Please pay attention to the correct reading distance from the scanner to the label (about 10 – 20cm).
• Damaged labels cannot be processed by the scanner.
• The simultaneous use of scanner and camera is impossible.

How can I configure the imager for the Remote Desktop Connection (RDP)?

You can make your settings for the imager at Start, Settings, System, "Imager Setting". Go to the tab "IMGRead", and select "Key Event" for the output. Confirm your settings with OK. Once you have finished making your settings, launch the imager wedge again at Start, "Image Scanner Read".

If data transfer from mobile terminal to PC is not complete, please try ELISA instead of the pre-installed Imager Scanner Read application.