The DT-X100 can either be equipped with a laser scanner or an imager (CMOS-Camera). You will find an overview with all readable codes in the software manual.

Laser Demo Tool (Barcode Demo)

You will find a demo program for simple tests and presentations under START, PROGRAMS, DEMO (only 10-models). The laser scanner can only read 1D barcodes or stacked 1D barcodes.

Under START, PROGRAMS, UTILITY you can find the program LASER SCANNER READ. This scanner wedge is running invisibly in the background and puts the collected to the respectively actual cursor position. If this wedge is used a complex own development can become unnecessary.

 Enhanced Laser and Imager Scanner Application

 As an enhancement to the integrated Imager / Laser Scanner Wedge Application, an Enhanced Laser and Imager Scanner Application ("ELISA") is available with enhanced features such as Bulk Scanning, Aimer Mode, Barcode Filter, Counter Window etc.

Scanner Setting

Setting for the laser scanner can be done under START, SETTINGS, CONTROL PANEL. The settings will be saved in a configuration file.

The settings are only valid for the scanner wedge (Laser Scanner Read) and own programs. The Laser Demo Tool (see above) does always run with the default settings.

Troubleshooting

Please check the points mentioned below:

• Use one of the trigger keys to start the scanner.
• The Scanner-Wedge can only be used when the symbol for the scanner is displayed in the status bar.
• The scanner only processes codes that have been activated with the matching settings.
• Please pay attention to the correct reading distance from the scanner to the label (4 – 55cm).
• Damaged labels cannot be processed by the scanner.